Friday 29 March 2013

Tour of the latest DATV-Express PCBA

I have just posted a video tour of the new PCB Assembly on YouTube.
DATV-Express v2 PCBA The video is better quality this time.

Enjoy it.

10 comments:

  1. Very Interesting Charles the explanation Keep up the good work

    ReplyDelete
  2. Charles,

    Informative video, thanks.

    The 5.5 V reg appears to be a switcher with the others linear, have you measured the native current draw at 12 Volts?

    Very broad RF output range, have you pushed it to see how much above 2480 it will go?

    Looking forward to getting one.

    Mike

    ReplyDelete
  3. No I have not but the modulator chip draws about 2 watts which is a bit disappointing.

    The range I quoted was the frequency range over which I managed to get it to lock. The low end is due to the size of the dividers in the chip and the high end is the VCOs internal to the chip. The VCOs actually operate at twice the output frequency so it is actually running at 4.8 GHz.

    ReplyDelete
    Replies
    1. I noticed from the data sheet that the ADRF6755 is a thirsty little guy. 4.8 is asking a lot considering that the highest their other PLL/VCO's go is 4GHZ. Mixing up to 9cm is not that big a deal, have to do it anyway to get to 3cm.

      Delete
    2. I plan using a 9 GHz Stellex YIG and SMA mixer for 10 GHz.
      For the PA I am going to use a 2W EYAL GAL unit
      http://www.rfdesign.co.uk/microwave/Content/Eyal-Gal-10GHz-Transceiver.pdf

      Delete
  4. How is things Going Charles on the Datv Express Front.

    ReplyDelete
  5. Hi, On the hardware side we are in the process of sorting out the various requirements for CE certification. On the software side I am about about to start testing some new FPGA code. I am hoping to have that done by the end of the month. There will be one final correction to the board layout before full manufacturing can start.

    - Charles

    ReplyDelete
  6. Charles,

    I still have a certain fondness for wideband FM ATV and was wondering if there might be a low cost embedded DSP solution for FM demod?

    Mike

    ReplyDelete
    Replies
    1. Hi Mike, the answer is no. FM TV uses a huge amount of bandwidth and you have to sample at twice the bandwidth minimum. There are a number of ways you can then process the signal, for example the dual differentiator algorithm, the arctangent detector or a phase lock loop. They are all computationally expensive. It is just so much easier to do it in analogue.

      Delete
  7. Thanks for the explanation.

    ReplyDelete